This help desk article covers the steps for replacing the battery in a DMP 1106 wireless door sensor.

Replacing the battery in the DMP 1106 Wireless Door Sensor is a quick and easy process that can be completed with a few simple steps. This article will guide you through the process of changing the battery in your door sensor so that you can keep your system functioning at its best.

Materials Needed:

  • A screwdriver with a flathead
  • A new CR 123 battery
  1. Removing the Old Battery The first step in the process of replacing the battery in your DMP 1106 Wireless Door Sensor is to remove the old battery. To do this, you will need to use a screwdriver with a flat head. Locate the hole on the sensor and insert the screwdriver into the hole. Twist the screwdriver slightly to release the battery from its compartment.
  2. Replacing the Battery Once you have removed the old battery, you can replace it with a new one. The DMP 1106 Wireless Door Sensor uses a CR 123 battery, so make sure you have one of these batteries on hand. Place the new battery in the compartment with the positive side facing up.
  3. Replacing the Cover Plate Finally, replace the cover plate on the sensor by sliding the top part in first and clipping it back into place.

Congratulations! You have successfully replaced the battery in your DMP 1106 Wireless Door Sensor. This should keep your system functioning smoothly and provide you with reliable protection. If you encounter any issues during the process, don't hesitate to reach out to a customer support specialist for further assistance.